Filter
Top Products
VISIBILITY IS LIMITED, USE THE EDGE
OF THE SHOE AS A GUIDE.
PROJECT TIPS
cleaner, faster and put less strain on the
motor while cutting.
shoe is firmly against the workpiece.
This will improve operator control and
minimize vibration.
These utilize a carbon steel back welded
to high speed steel teeth making the blade
more flexible and less prone to breaking.
MAINTENANCE
WARNING: REMOVE BATTERY
FROM SAW WHEN PERFORMING ANY
CLEANING OR OTHER MAINTENANCE.
WHEN SERVICING USE ONLY
IDENTICAL REPLACEMENT PARTS.
parts. Most plastics are susceptible to
various types of commercial solvents and
may be damaged by their use. Use only
mild soap and damp cloth to clean the tool.
immerse any part of the tool into a liquid.
fiberglass boats, sports cars, drywall
etc.,they are subject to accelerated wear
and possible premature failure, as the
fiberglass chips and grindings and drywall
dust are highly abrasive to bearings,
brushes, commutator, etc. During any
use on fiberglass or drywall it is extremely
important that the tool be cleaned
frequently by blowing with an air jet.
LUBRICATION
Your tool was properly lubricated before
leaving the factory. Once every year take
or send your tool to a
service center, or authorized service
station, for a complete cleaning, inspection
and lubrication. Tools “out of service” for
long periods should be relubricated before
being put back to work.
ACCESSORIES
Your reciprocating saw will accept up to a
blade suitable for your project. Longer blades
are more likely to be bent or damaged during
use. During operation, some longer blades
may vibrate or shake if the saw is not kept in
contact with the workpiece.
WARNING: S
ince accessories, other
than those offered by
,
have not been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury, only
recommended
accessories should be used with this product.
A complete line of accessories is available
from your
Factory Service
Authorized
Site www.blackanddecker.com for a catalog
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
installation.
charging requirements.
charger until LED illuminates.
working outlet. Refer to
for more details.
too hot or too cold. pack to a surrounding air
temperature of above
maximum thermal limit. down.
To
maximize the life of the allow to charge.
battery pack it is designed
to shutoff abruptly when
the charge is depleted.
For assistance with your product, visit our website www.blackanddecker.com for the location of the service
center nearest you or call the
help line at 1-800-544-6986.