Filter
Top Products
2928
07 PROGRAM DIGITAL DISPLAY – FLAT RATE BILLING
Find the Billing Rate
you recorded in section 05.
Enter your Billing Rate.
To make the numbers change
faster, you can press and hold
the or .
Do NOT enter a threshold.
Press the button until you
see dashes appear on the
Digital Display.
Programming is complete!
S T E P A C T I O N / P R E S S D I S P L AY
Billing Rate: = ¢/kWh
RECORD YOUR BILLING RATE HERE
Go to Section 10, Using Yo u r
Power Monito r.
Set day of the week.
Set temperature units.
Find your Power Factor (the number you recorded in
section 03 Installing Your Meter Sensor).
Enter your Power Factor.
Typical Power
Factors are:
7.2 for electromechanical meters
1.0 for electronic meters with
optical ports
Enter your Billing Mode:
TIER
for Flat or Tiered rates
2-PEAK
for Time-of-Use with two rates
3-PEAK
for Time-of-Use with three rates
S T E P A C T I O N / P R E S S D I S P L AY
06 PROGRAM DIGITAL DISPLAY -
TIME, DAY,
T E M P E R AT U R E , P OWER FACTOR, BILLING MODE
If your billing mode is Flat Rate, p roceed to section 07.
If your billing mode is T i e r ed Rate, p r oceed to section 08.
If your billing mode is Time-of-Use Rate, p roceed to section 09.
Power Factor = (usually 7.2 Kh)
90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 28