Filter
Top Products
7
ENGLISH
In this position there is no slip in the torque clutch. Select a
lower torque for insertion/removal of screws to avoid
damage to the work-piece (in particular wooden
work-pieces) or to the screw. For drilling select a higher
torque setting. Do a test first on an item which is not your
final work-piece and adjust the desired torque accordingly
before you start the actual work.
Operation for working
1. Using the Screwdriver as a Screw-driver
Before using the machine check whether the screw-bit is
inserted correctly. Avoid over-tightening screws, otherwise
the screw head may be damaged or stripping of the threads
may occur.
2. Screw Insertion
Set the direction of rotation of the drill to the clockwise
direction. Insert the screw-bit into the slot in the head of the
screw. Hold the screw bit perpendicular to the head of the
screw, otherwise the screw or the screw head may be
damaged. Press the screw bit against the screw with a
constant pressure while driving in the screw.
When the screw is completely screwed in, hold the machine
firmly and release the On/Off trigger, otherwise the screw or
the screw head may be damaged. If the On/Off trigger is not
released immediately a high torque could also damage the
drill bit or the drill.
3. Screw Removal
Set the direction of rotation of the drill to the anticlockwise
direction. Insert the screw-bit into the slot in the head of the
screw. Hold the screw-bit perpendicular to the head of the
screw, otherwise the screw or the screw head may be
damaged. Press the screw bit against the screw with a
constant pressure while removing the screw.
Maintenance and Cleaning
Attention! Always remove the battery before carrying out
any work on the machine.
To clean, always use a dry or moist, but not wet, towel. Many
cleaning agents contain chemical substances which may
cause damage to the plastic parts of the machine. Therefore
do not use any strong or inflammable cleaners such as
petrol, paint thinner, turpentine or similar cleaning agents.
Always keep air ventilation holes free of dust deposits to
prevent overheating.
Servicing
For more information on KC4815 and other products, please
visit us
Batteries
Black & Decker batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
• Run the battery down completely, then remove it from the
tool.
• NiCd, NiMH and Li-Ion batteries are recyclable. Take
them to any authorised repair agent or a local recycling
station.
Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and
packaging allows materials to be recycled and used
again. Reuse of recycled materials helps prevent
environmental pollution and reduces the demand for raw
materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have
reached the end of their working life. To take advantage of
this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.