Filter
Top Products
FIG. 45
54.
Lubrication
The gear case has been completely lubricated at the factory.
However, after six months to one year, depending upon use, it’s
wise to return your tool to the nearest Service Center for the
following:
• Brushes replaced.
• Parts cleaned and inspected.
• Relubricated with fresh lubricant.
• Electrical system tested.
• All repairs.
The following parts should be oiled occasionally with SAE No. 20
or No. 30 oil, or WD 40 (Fig. 45).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
Item Cat. No.
Folding Stand .........................................TS1000
Fixed Stand ...........................................TS1001
Outfeed Support ......................................TS1002
Dust bag..............................................TS1004
Zero Clearance Insert..................................TS1005
Dado Insert Set........................................TS1007
Molding Insert.........................................TS1009
Pusher Guide System..................................TS1010
Blade Tote ............................................TS1011
Use only recommended accessories. Follow
instructions that accompany accessories. Use of
improper accessories may cause hazards.
Recommended
Accessories
WARNING
!
2
1
2
3
3