Campbell Hausfeld CHN70899 Nail Gun User Manual


 
8
Glossary
Become familiar with these terms before operating the unit.
ACTUATE (TOOL) — To cause movement to the tool’s component(s) intended to
drive the fastener.
ACTUATION SYSTEM — The use of a trigger, work contact element (WCE) and/
or other operating control, separately or in combination or sequence, to actuate
the tool.
AIR INLET — The opening in which the compressed air supply is connected,
usually by means of a threaded fitting.
FASTENERS — The nailer uses fasteners ranging from 2 inches to 3-1/2 inches
long, from 0.113 inch to 0.131 inch in shank diameter, and from 31° to 34°.
MAGAZINE — The part of the nailer that holds the Fasteners.
MAXIMUM AIR PRESSURE — The maximum allowable pressure of compressed
air, as specified by the manufacture, for operating the tool.
NO-MAR DECKING TIP — The no-mar decking tip is designed to eliminate
marks caused by the serrated Work Contact Element (WCE). The no-mar tip may
be removed and tethered to the tool if not required (See REMOVING NO-MAR
DECKING TIP) or when a slightly deeper countersink is preferred. Simply slide
the no-mar off the WCE and attach to the retainer on the magazine. Use tool in
single cycle mode (SEE OPERATIONAL MODES) when no-mar tip is in place (see
Figure 5).
psi (POUNDS PER SQUARE INCH) —Measurement of the pressure exerted by
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
QUICK COUPLER — A quick coupler is designed to work in combination with a
quick plug to quickly and easily join a pneumatic tool to an air hose (see Figure 3).
QUICK PLUG — A quick plug is designed to work in combination with a quick
coupler to quickly and easily join a pneumatic tool to an air hose (see Figure 4).
REGULATOR — A device used to control air pressure to an air operated tool
THREAD LOCK GLUE — A locking glue that is applied to the screw threads
before installing. Prevents the screws from working loose during tool operation.
Figure 3 - Quick Coupler
Figure 4 - Quick Plug
Figure 5 - No-mar Decking Tip
www.chpower.com
CHN70899
Operating Instructions and Parts Manual