Filter
Top Products
6
Operating Instructions
www.chpower.com
Operating The Tool
(Continued)
An improperly
functioning tool
must not be used. Do not actuate the
tool unless the tool is placed firmly
against the work piece.
LOADING/UNLOADING THE TOOL
1. Always disconnect the tool from
the air supply before loading
fasteners.
2. Push
down on
the latch
button.
Pull back on the magazine cover.
3a. For nails,
insert a
stick of
Campbell
Hausfeld
nails or equivalent (see “Fasteners”
section) into the magazine. Make
sure the pointed ends of the
fasteners are resting on the bottom
ledge of the magazine when
loading. Make sure the nails are not
dirty or damaged.
3b. For
staples,
load a clip
of staples
with the
crowns straddling the magazine rail.
4. Push the
magazine
cover
forward
until latch
button pops up.
5. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except that you must disconnect
the air supply before unloading.
ADJUSTING THE FASTENER
PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so
fasteners are driven consistently. Do
not exceed 120 psi.
2. For shallow penetration, turn the
wheel (C) to right to the extent
desired.
3. For deeper penetration, turn the
wheel (C) to left to the extent
desired.
4. Make sure trigger and
work contact element
(WCE) move freely up
and down without
binding or sticking
after each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is
equipped
with an
adjustable
direction
exhaust deflector. This is intended to
allow the user to change the direction
of the exhaust. Simply twist the
deflector to any direction desired.
CLEARING A JAM FROM THE TOOL
1. Disconnect the air
supply from the tool.
2. Remove all
nails from
the magazine
(See Loading/
Unloading
The Nailer).
Failure to do so will cause the nails
to eject from the front of the nailer
when the nose assembly is removed.
3. Loosen cap screws on nose of tool.
Slide nose downward and remove
from tool to expose jammed
fastener.
4. Reinstall nose assembly in reverse
order in step #3.
5. Make sure the trigger and Work
Contact Element (WCE) move freely
up and down without sticking or
binding.
Failure to remove
all fasteners will
cause the fasteners to eject from the
front of the tool.
Latch
Button
Magazine Rail
(C)
Rotate