Filter
Top Products
Page 10
SKU 97510
93910
For technical questions, please call 1-800-444-3353.
MAINTENANCE
Disconnect the Nailer from the air source hose before attempting any maintenance.
1. Wipe tool clean with a lint free cloth and inspect it for damage. Do not use the tool if
you nd damage. Have it repaired by an authorized service technician.
2. Always test the Full Sequential Safety mechanism before each use (see page 6).
3. Keep all screws tight. Loose screws may damage the tool and cause personal injury.
4. Make sure that Base (29) is clear of all dirt or debris.
5. Make sure the Trigger (47) and Safety (41) move freely, without sticking. Do not
use nailer if Trigger or Safety sticks.
TROUBLESHOOTING
Any internal repair should be performed by a qualied service technician.
Symptom Cause Solution
Top of tool or Trigger (47)
leaks air, sluggish opera-
tion, or will not operate
1. Loose Screws,
2. Worn or damaged O-rings or
seals
3. Inadequate air supply,
4. Inadequate lubrication,
5. Worn/damaged O-rings or
seals
1. Verify screws are tight,
2. Check/replace O-rings or seals
3. Use a compressor that delivers the proper
CFM,
4. Add air tool oil (not incl.),
5. Check/replace O-rings or seals
Bottom of tool leaks air 1. Loose Screws,
2. Worn/damaged O-rings,
seals.
1. Verify screws are tight,
2. Check/replace O-rings, seals.
Frequent Jamming Nail-type does not correspond
with the adjustment angle
setting.
Ensure nail-type loaded corresponds to the
adjustment angle setting. Nail types are as
follows:
21° Plastic Collated Full Head Nails
28° Paper Collated Clip Head Nails
34° Paper Collated Clip Head Nails
Tool double-res All 3 adjustment locations are
not set at the same angle (see
Figures 1-6 on page 7.)
Set all 3 adjustment locations at the same
angle, whether its 21°, 28°, or 34°.
Adjustment pin (33, 34)
will not remove
The rubber O-ring at the tip of
the pin (Fig. 6, page 7) is tight-
tted.
Remove rubber O-ring with a small athead
screwdriver. The upper hole corresponds
to 28°/34° and the lower hole to 21°. Make
adjustment and secure pin with rubber O-ring.
REV 08j