Filter
Top Products
Page 2
SKU 97510
93910
For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Air Inlet 1/4” NPT
Recommended Air Pressure 70-125 PSI*
Maximum Air Pressure 125 PSI
Nail Type Approx. 10 Gauge (0.113 & 0.131” Dia.) Clipped or Full Head Nails
2 - 3-1/2” Length
Safety Feature Full Sequential Actuation
Magazine Capacity 21° - 60 Qty., 28° and 34° - 100 Qty.
Air Consumption 8-12 CFM @ 90 PSI
* The air pressure setting must not exceed job site regulations/restrictions. The air
pressure setting must not exceed 90 PSI when being used with work pieces that
have a thickness of less than 1-3/4”.
Note: Performance of the compressor (if powered by line voltage) may vary depending on
variations in local line voltage. Extension cord usage may also affect tool performance.
SAVE THIS MANUAL
You will need the manual for the safety warnings and precautions, assembly instruc-
tions, operating and maintenance procedures, parts list and diagram. Keep your invoice
with this manual. Write the invoice number on the inside of the front cover. Keep the
manual and invoice in a safe and dry place for future reference.
SAFETY WARNINGS AND PRECAUTIONS
WARNING: When using tool, basic safety precautions should always be
followed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lit. Do not use electrically powered
tools in the presence of ammable gases or liquids.
3. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, extension cords, or air hoses.
4. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
5. Use the right tool for the job. Do not attempt to force a small tool or attachment to
do the work of a larger industrial tool. There are certain applications for which this tool
was designed. It will do the job better and more safely at the rate for which it was in-
tended. Do not modify this tool and do not use this tool for a purpose for which it was
not intended.