Filter
Top Products
Page 9
SKU 97510
93910
For technical questions, please call 1-800-444-3353.
CLEARING JAMS
1. Disconnect tool from air hose. Always re the trigger repeatedly to make sure all of
the air is expended from the Nailer.
2. If a nail is jammed in the discharge area, simply
remove it with pliers.
3. If a nail is jammed in the magazine, pull the Tab
(70) all the way back to the engaged position. Using
a screwdriver, attempt to release the jammed nail
by probing either or both of the two openings in the
magazine (see photo at right) to release the nail.
Pull out the jammed nail and the remainder of the
nail strip that is still in the magazine.
4. Dispose of the remaining nail strip; it may be bent
or damaged in some other way. Reload the maga-
zine with a new nail strip.
5. Be careful. When you pull back on the Latch (83) to release the Tab (70), it will
spring forward with force. Keep your ngers clear when you release the Latch (83)
and slide the Tab (70) forward.
6. If you are unable to clear the nail jam using the method prescribed above, the
tool should be taken to a qualied service technician for proper servicing.
Figure 7
Probe in these areas with a
screwdriver to release jammed nails.
Anytime any maintenance or repairs are done (including clearing jams), FIRST:
1. Disconnect the Nailer from the air hose.
2. Empty the Magazine (76) completely.
3. Attempt to re the Nailer into a piece of scrap wood to ensure that it is disconnected
and is incapable of ring any nails.
4. Always leave the Magazine (76) open during maintenance. The Magazine is
spring-loaded and may cause parts or a nail to y out of the Nailer.