Filter
Top Products
Page 10 of 20 Intimidator™ Spot LED 250 User Manual Rev. 11
Configuration
(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a startin
g address that is too high, you could
restrict the access to some of the product’s channels.
The Intimidator™ Spot LED 250 uses up to 13 DMX channels in its 13-
channel DMX
mode, which defines the highest configurable address to 500.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com
.
To select the starting address, do the following:
1. Press <MODE/ESC> repeatedly until 001 shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
DMX
Personalities
The Intimidator™ Spot LED 250 has two DMX personalities, an 8-
channel personality and
a 13-channel personality.
To choose which DMX personality to use, follow the steps below:
1. Press <MODE/ESC> repeatedly until either 13CH (to choose the 13-channel
personality) or 8CH (to choose the 8-channel personality) shows on the display.
2. Press <ENTER>.