Filter
Top Products
Intimidator™ Spot LED 250 User Manual Rev. 11 Page 17 of 20
Changing
Gobos
To change the gobos in the Intimidator™ Spot LED 250
, you do not need to remove the
gobo wheel. Simply:
1. Turn off and disconnect product from power.
2. Place the product on a flat, level surface with the front facing up.
3. Open the gobo-access plate by pushing it in the direction of the arrow.
4. Rotate the gobo wheel until the gobo that needs replacing is accessible.
5. Separate the gobo holder assembly
away from the gobo wheel by pushing it
forward and up. Be careful not to push the gobo out of the gobo plate.
6. Extract the gobo holder by pulling it backwards out of the product.
7. On a flat surface, remove the ex
pansion ring that holds the gobo in place and
remove the gobo from the gobo plate.
8. Insert a new gobo and hold it in place with the expansion ring.
9. To re-
insert the new gobos, slide the tip of the gobo holder under the pressure plate
near the center of the gobo wheel.
10. Push the gobo holder assembly
inwards. DO NOT force the gobo holder into the
gobo wheel slot. Slightly move the holder from side-to-
side if needed to get it to seat
properly. If correctly installed, the bottom of the holder will be flush with t
he gobo
wheel.
11. Push cover back into position.
Gobo Replacement Diagram
Gobo Wheel Detail Views
Expansion Ring
Gobo
Gobo Holder
Assembly
Gobo Holder Removal
Easy-access
Panel