Filter
Top Products
Safety Instructions
Please read these instructions carefully, which includes
important information about the installation, usage and
maintenance of this product.
• Please keep this User Guide for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
• Always make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal or rear
panel of the fixture.
• This product is intended for indoor use only! (If applicable)
• To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make
sure there are no flammable materials close to the unit while operating.
• The unit must be installed in a location with adequate ventilation, at least 20in
(50cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.
• Always disconnect from power source before servicing or replacing lamp or fuse
and be sure to replace with same lamp source.
• Secure fixture to fastening device using a safety chain. Never carry the fixture
solely by its head. Use its carrying handles.
• Maximum ambient temperature (Ta) is 104°F (40°C). Do not operate fixture at
temperatures higher than this.
• In the event of a serious operating problem, stop using the unit immediately.
Never try to repair the unit by yourself. Repairs carried out by unskilled people
can lead to damage or malfunction. Please contact the nearest authorized
technical assistance center. Always use the same type spare parts.
• Never connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on.
• Do not daisy chain power to more than # units. (If applicable)
Caution! There are no user serviceable parts inside the unit. Do not open the
housing or attempt any repairs yourself. In the unlikely event your
unit may require service, please contact CHAUVET at: 954-929-1115.
Derby X™ User Manual 4 7/14/2008 1:27 PM