Filter
Top Products
Master/Slave Fixture Linking
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin
connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3
pin connector to the input connector of the next fixture consisting of a (male) 3 pin
connector. Then, proceed to connect from the output as stated above to the input of the
following fixture and so on.
Often, the setup for Master-Slave
and Standalone operation requires
that the first fixture in the chain be
initialized for this purpose via either
settings in the control panel or DIP-
switches. Secondarily, the fixtures
that follow may also require a slave
setting. Please consult the
“Operating Instructions” section in
this manual for complete instructions
for this type of setup and
configuration.
Slave Slave Master
Mounting
ORIENTATION
This fixture may be mounted in any safe position provided there is adequate room for
ventilation.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a
suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and
tilting the fixture. After finding the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp replacement access and
routine maintenance.
• Safety cables must always be used.
• Never mount in places where the fixture will be exposed to rain, high humidity, extreme
temperature changes or restricted ventilation.
Hanging Clamp
Note!
Clamp is sold separately.
Derby X™ User Manual 8 7/14/2008 1:27 PM