Filter
Top Products
Appendix
TFX-950CM User Manual 20 Revision: 2006-01-20/16:37
General Troubleshooting
Applies to
Symptom Solution(s)
Lights
Foggers
& Snow Controllers
Dimmers&
Chaser
Auto shut off Check fan thermal switch reset
Beam is very dim or
not bright
Clean optical system or replace lamp
Check 220/110v switch for proper setting
Breaker/Fuse keeps
blowing
Check total load placed on device
Chase is too slow Check users manual for speed adjustment
Device has no power Check for power on Mains.
Check device’s fuse. (internal and/or external)
Fixture is not
responding
Check DMX Dip switch settings for correct
addressing
Check DMX cables
Check polarity switch settings
Fixture is on but there
is no movement to the
audio
Make sure you have the correct audio mode on the
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
Lamps cuts off
sporadically
Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.
Light will not come on
after power failure
Some discharge lamps require a cooling off period
before the electronics in the fixture can kick start it
again, wait 5 to 10 minutes before powering up
Loss of signal Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power
cables or black lights.
Moves slow Check 220/110v switch for proper setting
No flash Re-install bulb, may have shifted in shipping
No laser output Bounce mirror motor may have shifted during
shipping, readjust
No light output Check slip ring & brushes for contact
Install bulb
Call service technician
Relay will not work Check reset switch
Check cable connections
Remote does not work Make sure connector is firmly connected to device
Stand alone mode All Chauvet lighting fixtures featuring stand-alone
functions do not require additional settings, simply
power the fixture and it will automatically enter into
this mode