Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. SKU 66615
General Operating Instructions
To Wax An Object:
Attach the Foam Bonnet (53) to the 1.
Mounting Disc (51) as previously
discussed in this manual.
NOTE: Prior to waxing an object, make sure
the surface has been thoroughly cleaned
and is free of dust, dirt, oil, grease, etc.
Apply about two tablespoons of polishing 2.
liquid or wax (not included) evenly on
the Foam Bonnet (53). Do not apply
the polishing liquid or wax directly to
the object’s surface. The amount of
polishing liquid or wax needed will vary
according to the object’s size. Avoid
using too much polishing liquid or
wax. The Foam Bonnet will not absorb
as much polishing liquid or wax in
subsequent applications.
Plug the Power Cord (5) into the nearest 3.
120 volt, grounded, electrical outlet.
In order to keep the Power Cord (5) out 4.
of the way, hang it over your shoulder.
IMPORTANT: Start and stop the Polisher
surface of the object being waxed.
Failure to do so may result in the Foam
Bonnet (53) being thrown from the
Mounting Disc (51).
5.
Then turn the Power Switch (11) to its
“ON” position. (See Figure C.)
DISPLAY
(10)
POWER
SWITCH (11)
– SPEED
BUTTON (12)
+ SPEED
BUTTON (13)
FIGURE C
6. Increase the tool’s speed by pressing
the + Speed Button (13). Decrease the
tool’s speed by pressing the – Speed
Button (13). (See Figure C.)
The Display (10) will indicate the tool’s 7.
speed.
NOTE:
start the tool at its lowest speed to avoid
throwing wax off the Foam Bonnet (53).
Then increase the speed as needed.
Begin applying polishing liquid or wax 8.
to the object. Apply the polishing liquid
pattern. Apply the polishing liquid or wax
evenly over the surface of the object,
and add additional polishing liquid or wax
as needed.
After the polishing liquid or wax has been 9.
applied to the object’s surface, turn the
Power Switch (11) to its “OFF” position.
Then unplug the Power Cord (5).
(See Figure C.)
Remove the Foam Bonnet (53) from 10.
the Mounting Disc (51). With the Foam
Bonnet in your hand, apply the polishing
liquid or wax to all hard to reach areas of
the object. (See Figures A and B.)
REV 10b