Filter
Top Products
Page 14 For technical questions, please call 1-800-444-3353. SKU 66615
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual must
be performed only by a qualied
technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch (11) off
and unplug the Polisher from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Inspection, Maintenance, and
Cleaning
BEFORE EACH USE, inspect the 1.
general condition of the Polisher.
Check for loose screws, misalignment
or binding of moving parts, cracked or
broken parts, damaged electrical wiring,
and any other condition that may affect
its safe operation.
AFTER USE,2. clean external surfaces
of the tool with clean cloth. Do not
immerse any part of the tool in liquid.
Remove the Bonnet (52, 53) from the
tool when not in use. This will allow
the Bonnet to dry and retain its original
washed in cold water with detergent.
medium heat.
CARBON BRUSH MAINTENANCE: 3.
IMPORTANT: Cleaning or replacing
the Carbon Brushes (19) should
only be done by a qualied service
technician.
The Carbon Brushes (19) may a.
require maintenance when the motor
performance of the tool decreases or
stops working completely. To maintain
the Brushes:
b.
(2,9).
Remove the two Carbon Brushes (19) c.
from the housing. Keep track of which
orientation the old Carbon Brushes
were in to prevent needless wear if they
will be reinstalled.
If either Carbon Brush (19) is worn d.
both
Carbon Crushes.
To clean old Carbon Brushes (19) e.
before reusing them, rub the contact
areas with a pencil eraser.
Reinsert the old Carbon Brushes (19) in f.
the same orientation to reduce wear.
When installing the Carbon Brushes g.
(19), make sure the carbon portions of
the Carbon Brushes contact the Motor
Armature, and that the Springs face
away from the Motor. Also, make sure
the Springs operate freely.
Note: New Carbon Brushes (19) tend to
conform to the Motor’s Armature.
4. WARNING! If the Power Cord (5) of
this Polisher is damaged, it must be
replaced only by a qualied service
technician.