Filter
Top Products
Page 4 For technical questions, please call 1-800-444-3353. SKU 66615
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool
accidentally.
Store idle power tools out of the reach d.
of children and do not allow persons
unfamiliar with the power tool or
these instructions to operate the
power tool. Power tools are dangerous
in the hands of untrained users.
Maintain power tools. Check for e.
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool’s operation. If damaged, have
the power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. f.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
Use the power tool, accessories and g.
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
Service5.
Have your power tool serviced by a a.
qualied repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
Safety Warnings Common for
Sanding or Polishing Operations
This power tool is intended to 1.
function as a sander or polisher. Read
all safety warnings, instructions,
illustrations and specications
provided with this power tool. Failure
to follow all instructions listed below
serious injury.
Operations such as grinding, wire 2.
brushing, or cutting-off are not
recommended to be performed with
this power tool. Operations for which
the power tool was not designed may
create a hazard and cause personal
injury.
Do not use accessories which 3.
are not specically designed
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the accessory 4.
must be at least equal to the
maximum speed marked on the power
tool. Accessories running faster than
apart.
The outside diameter and the 5.
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
guarded or controlled.
The arbor size of wheels, anges, 6.
backing pads or any other accessory
must properly t the spindle of the
power tool. Accessories with arbor
holes that do not match the mounting
hardware of the power tool will run out
of balance, vibrate excessively and may
cause loss of control.
Do not use a damaged accessory. 7.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad
REV 10b