Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. Item 69275
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TOOL SET UP
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position, remove the key, and unplug the tool
from its electrical outlet before assembling or making any adjustments to the tool.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Installing Blade
1. Unplug the saw.
2. Turn the Guard Knob counterclockwise.
3. Open the Guard to expose the Spindle.
4. Loosen the Spindle Nut counterclockwise
and remove the old Blade, if installed.
5. Place the Inner Flange onto the Spindle.
Install with the cupped side of the
Inner Flange facing the tile saw housing.
6. Wipe a drop of oil onto the Inner Flange
where it will contact the Blade.
WARNING! TO PREVENT SERIOUS INJURY:
Only use a smooth rim, wet cutting, 10″ Blade rated
to at least 3,800 RPM on this tool.
Do not use a Blade that is too thick to allow Outer Flange
to engage with the flats on the Spindle.
Do not use a Blade that has openings, grooves, or teeth.
7. Slide the Blade (sold separately) onto Spindle.
8. Place Outer Flange onto the Spindle.
The flats on the Outer Washer align with the
flats on the Spindle. Install with the cupped
side of the Outer Flange facing the blade.
9. Place Spindle Nut on Spindle.
10. Press and hold the Spindle Lock in.
11. Wrench-tighten Spindle Nut securely.
Release the Spindle Lock.
12. Close the Guard, and use the
Guard Knob to secure it.
Figure I: Blade Assembly
Inner
Flange
Blade
Outer
Flange
Spindle
Nut
Spindle
Lock
Wrench
Blade Guard
Guard
Knob
Figure J: Securing Blade