Filter
Top Products
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
SKU 91814 PAGE 11
ASSEMBLY INSTRUCTIONS
1. Connect a 3-prong, 220 VAC, polarized, twistlock plug (not supplied) to the Line Cord.
This plug must be installed by a qualified electrician.
2. Attach the Pressure Gauge to the Air Regulator (58). Then install the Air Regulator to
the Air Inlet (8) on the rear of the Plasma Cutter, with the arrow pointing towards the
Plasma Cutter. See photo below.
CONTROLS AND INDICATORS
Power
Indicator (6)
Welding
Indicator (5)
Overheat
Indicator (4)
Cable Plug
Grounding Cable Clamp (-)
Quick Coupler (11)
Air Hose
Current
Adjustment
Knob (3)
Torch Cables
(53) (+)
Grounding Cable/Clamp (54)
REAR VIEW
Torch Handle
Trigger
Air Outlet (10)
Power
Switch (7)
Air Regulator (58)
Protective Boot