Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.SKU 94056
Know proper welding practices24. .
Read and understand the
manufacturer’s instructions, as well
as your employer’s safety practices
for welding.
Connect only to a code approved 25.
power source. Connect only to a
grounding power source conforming
to the National Electrical Code and
Local Codes.
Avoid re and explosion26. . Remove
ammable and explosive material
from at least 35 feet from the welding
site to prevent welding sparks or
molten metal from starting a re.
Keep a type ABC re extinguisher
within easy reach. Thoroughly clean
the object being welded of any paint,
grease, or other foreign material.
Avoid being burned27. . Always wear
ANSI-approved welding gear: leather
gloves, leather apron, and shoes.
WARNING: This product, when used 28.
for welding, plasma cutting, soldering,
or similar applications, produces
chemicals known to the State of
California to cause cancer and birth
defects (or other reproductive harm).
(California Health & Safety Code §
25249.5, et seq.)
The warnings, cautions, and 29.
instructions discussed in this
instruction manual cannot cover
all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into
this product, but must be supplied
by the operator.
UNPACKING
When unpacking, check to make sure
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at 1-800-444-3353 as
soon as possible.
ASSEMBLY
Cover
Locking
Spring (8)
Cover (31)
Handle (30)
Wire
Reel (27)
1. Attach the Handle (30) to the Cover
(31) using screw (29) inserted from the
Handle top-rear.
Attach the Cover Locking Spring (8) to 2.
the front of the Base Frame (14) using
the supplied self-tapping screw.