Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 94056
Lay the Torch Sheath out in a straight 11.
line so that the wire moves through it
easily.
Warning: The following steps require
applying power to the welder. Do not
touch anything with the Torch Handle
or an arc may be ignited.
Plug the Power Cord into its electrical 12.
outlet, press the Current Switch to
Max., and turn the welder ON.
Lift the Torch Handle and continue 13.
pressing the Trigger until the wire
feeds through two inches.
If the wire does not feed, view the
Wire Feed Unit and see if the wire
is being pushed. If it is not, turn the
welder OFF and tighten the Wire
Feed Knob (37a).
Turn the welder ON again and press 14.
the Trigger.
Once the wire is exposed, turn the 15.
welder OFF and unplug it.
Slide the Contact Tip over the wire 16.
and screw it into Torch Handle.
Replace the Nozzle and cut off any 17.
excess wire over two inches.
Secure the Cover.18.
PLEASE READ THE
FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL
ONLY. NEITHER THE MANUFACTURER NOR
DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE
ANY REPAIRS TO THE PRODUCT OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY
PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO
THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS
THERETO.