Filter
Top Products
English
Page 10
SKU 94245 For technical questions, please call 1-800-444-3353
UNPACKING
When unpacking, check to make sure that the following parts are included: Circular Saw,
Hex Wrench, and Guide Fence. Refer to the Assembly section, and the Assembly Drawing
and Parts List at the end of this manual. If any parts are missing or broken, please call
Harbor Freight Tools at the number on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
Adjusting the Saw Prior to Cutting
CAUTION: Always make sure the Power Cord is unplugged from its electrical outlet
prior to making any adjustments to the tool.
1. To adjust the angle of blade from 0 to 45 degrees, loosen Wing Nut (10) and move
Base Plate (4) down, observing the degrees indicated on the Angle Bracket (6).
Tighten Wing Nut (10).
2. To adjust the depth of the cut, lift Depth Lever (38) and move Base Plate (4) down (or
up) while observing the amount of saw blade exposed under Base Plate. Push down
on the Depth Lever (38) to lock in new depth setting.
Controls and Adjustments
Switch Lock ButtonSwitch (61) Trigger
Angle Adjust
Wing Nut (10)
Depth Lever (38)
Handle Grip
Base Plate (4)