Filter
Top Products
SKU 95380 For technical questions, please call 1-800-444-3353 PAGE 6
17. Never cut pieces too small to be held securely against the
Table’s Fence without leaving enough space for the hand to
be a safe distance from the Router Bit (not included).
18. Make sure the Table and surrounding area are clear
with the exception of the workpiece to be cut.
19. Before each use of the Router, make sure it is
securely attached to the Router Table.
20. The Router Table is designed for cutting at workpieces
only. Do not attempt to cut workpieces that are not at.
21. The Router and Router Table are designed for cutting
wood workpieces only. Do not attempt to use the Router
and its Table to cut metal or other non-wood materials.
22. Never attempt to cut more than one workpiece at a time.
23. Always make sure the work surface of the Router Table is
clean and free of dust, wood chips, and other debris that
can interfere with the cut you are going to make.
24. Always keep children and other unauthorized people away
from the Router Table. Unplug the Table, and remove the
Power Switch’s Safety Key when the Table is not in use.
25. Never reach under the Router Table for any
reason when the Router is running.
26. Avoid overloading the Router. If the speed drops abnormally,
decrease the pressure on the workpiece immediately.
27. Use the right tool for the job. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. It will do the job better and
more safely at the rate for which it was intended. Do not modify this tool,
and do not use this tool for a purpose for which it was not intended.
28. Always use sharp Router Bits (not included). If the Bit stops
abruptly, or the Bit becomes blocked, turn the Router Table’s
Power Switch to its “OFF” position immediately.
29. Before routing, run the Router for about ten seconds to ensure
all moving parts are running smoothly and there are no loose
parts, rattles, or sparking that would indicate damage.
30. WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of
California) to cause cancer, birth defects or other reproductive harm. Some