Filter
Top Products
Page 16 For technical questions, please call 1-800-444-3353. SKU 96035
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual must
be performed only by a qualied
technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Release the Trigger and unplug
the tool from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check for
loose hardware, misalignment or binding
of moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
AFTER USE,2. wipe external surfaces of
the tool with clean cloth.
Breaker Hammer will cease operation 3.
once Carbon Brushes are worn.
Check Brushes every 100 hours and,
when necessary, replace them.
4.
use to remove all dust and grit from the
tool.
Add a drop or two of a lightweight oil to
5.
the Trigger assembly area to lubricate
the Trigger (86).
Examine the tool before each use. Make
6.
sure the Chisel is sharp and not dull
or cracked. Replace worn or broken
Chisels with approved replacement
Chisels from Harbor Freight Tools.
7.
60° F.
8. WARNING! If the supply cord of
this power tool is damaged, it must be
replaced only by a qualied service
technician.