Page 13SKU 96448 For technical questions, please call 1-800-444-3353.
When nished, release the Trigger to stop the Impact Wrench. Then, remove the 7.
Battery and socket from the tool.
Make sure to store the Impact Wrench in a dry, clean location out of reach of chil-8.
dren and other unauthorized people.
MAINTENANCE AND SERVICING
Risk of serious personal injury from accidental starting or
electric shock. Turn the Forward/Reverse Switch to the
center, locked position and disconnect the Battery before
performing any inspection, maintenance, or cleaning
procedures.
Damaged equipment can fail, causing serious personal
injury. Do not use damaged equipment. If abnormal noise or
vibration occurs, have the problem corrected before further
use.
Cleaning and Maintenance
BEFORE EACH USE,1. inspect the general condition of the tool. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, and any other condition that may affect its safe operation.
AFTER USE,2. clean external surfaces of the tool with clean, moist cloth.
WARNING! If the supply cord of this power tool is damaged, it must be 3.
replaced only by a qualied service technician.
Dispose of the rechargeable NiCd battery according to State, Local and Federal 4.
regulations. Contact a local recycling center for disposal directions.
Replacing the Carbon Brushes
It may become necessary at sometime to replace or clean the two Carbon Brush-1.
es (29) when the Motor performance decreases, or stops working completely.
Remove the two Brush Holder Caps (28), then the two Carbon Brushes (29), 2.
keeping track of the orientation and location of each.
If either Carbon Brush is worn more than halfway, replace both Carbon Brushes. 3.
If the Carbon Brushes are just dirty, however, they may be cleaned by rubbing
them with a pencil eraser. If cleaning used brushes, try to install them in the
same holders and orientation as when they were removed.
WARNING