Filter
Top Products
4-2
Cisco 819 Integrated Services Router Hardware Installation Guide
OL-23125-02
Chapter 4 Initial Configuration
Cisco IOS CLI
Step 2 Press Return. The following message is displayed:
Cisco Configuration Professional Express (Cisco CP Express) is installed on this device.
This feature requires the one-time use of the username "username1"
with the password "password1." The default username and password have a privilege level of
15.
Please change these publicly known initial credentials using Cisco CP Express or the Cisco
IOS CLI.
Here are the Cisco IOS commands.
username <myuser> privilege 15 secret 0 <mypassword>
no username username1
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about Cisco CP please follow the instructions in the QUICK START
GUIDE for your router...
...
User Access Verification
Username:
Step 3 Enter the username username1 and press Return or Enter. The following prompt is displayed:
Password:
Step 4 Enter the password password1 and press Return or Enter. The following prompt is displayed:
Router#
A message is displayed that is similar to the first warning message. The message directs you to change
the username and password.
You are now in privileged EXEC mode.
Note You must change the username and password before you log off the router. You cannot use the
username username1 or password password1 after you log off from this session.
Step 5 To change the username and password, enter the following at the prompt:
username username privilege 15 secret 0 password
The username and password are the username and password that you determine.
To continue using the Cisco IOS CLI for initial configuration, see the applicable configuration
procedures in
Cisco 819 Integrated Services Routers Software Configuration Guide.
Note Save your configuration changes regularly to avoid losing them during resets, power cycles, or
power outages. Use the copy
running-config startup-config command at the privileged EXEC
mode prompt (Router#) to save the configuration to NVRAM.
Step 6 Verify the initial configuration. See the “Verifying the Initial Configuration” section on page 4-5.