Filter
Top Products
INSTALLING EXTENSION WINGS (FIG. E)
To avoid injury or possible damage to the tool, support
long work pieces by installing the extension wings to
extend the work support surface.
When using extension and stop block on the right side,
hold down clamp must also be in right side. Using
hold down clamp on the left side during this operation
can cause kick-back and serious injury to the
operator.
INSTALLING THE STOP BLOCK (FIG. E):
1. Slide the stop block (1) onto the extension wing (2)
2. Thread the wing bolt (4) into the stop block and tighten.
INSTALLING THE EXTENSION WINGS (FIG. E):
1. Place the extension wing into the mounting holes (5)
provided in the miter saw base.
2. Thread the extension wing locking screw (6) into the
treaded hole (7) and tighten to secure extension in place.
Fig. E
REMOVING OR INSTALLATING THE BLADE
Only use a 10-inch diameter blade. To avoid injury
from an accidental start, make sure the switch is in the
OFF position and plug is not connected to the power
source outlet.
REMOVING (Fig. F, G, H)
1. Unplug the saw from the outlet.
2. Allow the blade assembly to rise to the uppermost
position. Raise the lower blade guard (1) to the upper
position. (Fig. F)
3. Loosen the cover plate screw (2) with a Phillips
screwdriver (Fig. F).
4. Rotate the cover plate (3) to expose the arbor bolt
(4) - (Fig. F).
5. Place the blade end wrench over the arbor bolt.
Fig. F
6. Locate the arbor lock (5) on the motor, below the miter
saw switch handle. (Fig. G)
7. Press the arbor lock, holding it in firmly while turning the
blade wrench clockwise. The arbor lock will engage after
turning the wrench. Continue to hold the arbor locking to
keep it engaged, while turning the wrench clockwise to
loosen the arbor bolt.
8. Raise the lower clear plastic blade guard (1) to the
upright position. (Fig. F)
Fig. G
REMOVING – cont’d
9. Remove the arbor bolt/washer (4), laser guide (6), and
the blade (7). Do not remove the inner blade collar.
(Fig. H)
NOTE: Pay attention to the pieces removed, noting their
position and direction they face. Wipe the laser guide clean
of any sawdust before installing the new blade.
11