Filter
Top Products
To avoid injury from an accidental start, make sure the
switch is in the OFF position and the plug is not
connected to the power source outlet.
45
o
Bevel Adjustment (Fig N)
1. Unlock the bevel lock handle and tilt the cutting head
completely to the left.
2. Using a combination square, check to see if the blade
angle is 45
o
to the table.
3. If the blade is not at 45
o
to the miter table, tilt the
cutting arm to the right, turn the bevel angle
adjustment bolt (4) in or out with a 5mm hex. wrench
accordingly.
4. Tilt the cutting arm to the left to 45
°
bevel and recheck
for alignment.
5. Repeat steps 1 through 4 until the blade is at 45
o
to
the miter table.
Fig. N
MOUNTING THE MITER SAW (Fig. O)
To avoid injury from unexpected saw movement:
Before moving the saw, disconnect the power cord
from the outlet, and lock the cutting arm in the lower
position using the stop latch.
NOTE:
The stop latch is for carrying or storing the tool. It is
NOT to be used holding the saw while cutting.
Never carry the miter saw by the power cord or by the
switched handle. Carrying the tool by the power cord
could cause damage to the insulation or wire
connections resulting in electric shock or fire.
To avoid injury from flying debris, do not allow visitors
to stand behind the saw.
Place the saw on a firm, level work-surface where
there is room for handling and properly supporting the
workpiece.
Support the saw on a level work surface.
Bolt or clamp the saw to its support.
Place the saw in the desired location, either on a work
bench or recommended leg set. The base of the saw has
three mounting holes (1).
- For stationary use,
fasten the saw to a workbench.
- For portable use, fasten the saw to a 3/4” piece of
plywood. This mounting board can then be clamped to a
secure surface.
Fig. O
14
Portable Use
3/4 Inch Plywood
Stationary Use