Filter
Top Products
22 23
22 23
● NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use,
some occasional readjustments
may be necessary.
● CAUTION-Use of controls or
adjustments or performance of
procedures other than those
specified herein may result in
hazardous radiation exposure.
● CAUTION-The use of optical
instruments with this product will
increase eye hazard.
● Do not attempt to repair or
disassemble the laser. If
unqualified persons attempt
to repair this laser product,
serious injury may result. Any
repair required on this laser
product should be performed
by authorized service center
personnel.
A. Check Laser Beam Alignment.
1. Mark a 90° straight line across a
board to serve as a “pattern line” to
test laser alignment. Lay the board
on the miter table.
2. Plug saw into outlet and turn on the
laser beam and line it up with the
pattern line.
3. Lower saw blade to pattern line and
if blade is not flush with the pattern
line, adjust as follows in procedure
(B).
B. Adjusting the Angle of the Laser
Trac
®
(Fig. P)
1. Turn the laser element (2) in the
desired direction to adjust the laser
angle. NOTE: Do not adjust the
laser more than 1/4 turn in either
direction as this may damage the
laser. There are two flat sides on
ALIGNING THE LASER BEAM (FIG.
O, P)
For your own safety, never connect
the plug to power source outlet
until all the adjustment steps
are complete and you have read
and understood the safety and
operational instructions.
The laser beam must always be
correctly aligned with the blade to
ensure straight, even cutting.
Your tool is equipped with the Laser
Trac
®
cutting guide using Class II laser
beam. The laser beam will enable to
preview the saw blade path on the
stock to be cut before starting the miter
saw. This laser guide is powered by the
transformed alternating current supply
directly through the power lead. The
saw must be connected to the power
source and the laser on/off switch
must be turned on for the laser line
to show.
AVOID DIRECT EYE CONTACT
● Laser radiated when laser guide
is turned on. Avoid direct eye
contact. Always un-plug the miter
saw from power source before
making any adjustments.
● Laser Warning Label: Max output
<1mW DIODE LASER: 630-670nm,
Complies with 21CFR 1040.10 and
1040. 11.
WARNING
!
WARNING
!