Filter
Top Products
2 3
2 3
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be
connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these
safety rules. Failure to follow these rules could result in serious injury to
you or damage to the tool.
MOTOR
Power Source ............................... 120V AC, 60Hz, 15 Amp
Speed ........................................... 4200 RPM (No load)
Brake ............................................ Electric
Double Insulated ........................... Yes
Motor Arbor Shaft Size .................. 5/8 in.
BLADE SIZE
Diameter ....................................... 12 in.
Arbor size ...................................... 1 in. w/a 5/8 in. reducer
ROTATING TABLE
Diameter ....................................... 13-7/16 in.
Miter Detent Stops ........................ 0, 15, 22.5, 31.6, 45º R & L, 60º R
Bevel Positive Stops ..................... 0, 33.9, 45º R & L
CUTTING CAPACITY
Crosscut ........................................ 4 in. x 12-1/4 in.
Miter 45° R & L; 60º R .................... 4 in. x 8-3/4 in. R & L ; 4 in. x 6-1/4 in. R
Bevel 45º R & L ............................. 2-1/2 in. x 12-1/4 in. L ; 1-3/4 in. x 12-1/4 in. R
45° Miter and 45° Bevel R & L........ 2-1/2 in. x 8-3/4 in.
60º Miter and 45º Bevel R .............. 1-3/4 in. x 6-1/4 in.
PRODUCT SPECIFICATIONS