Filter
Top Products
35
Fig. Z
NOTE: The saw comes with a 33.9°
crown molding stop.
33.9° BEVEL STOP FOR CROWN
MOLDING (FIG. AA)
1. Push the bevel detent stop pin (2) in
toward the front of the machine.
2. Loosen the bevel lock handle (1).
3. Rotate the cutting head until the
bevel detent pin stops the bevel
angle at 33.9° on the bevel scale.
4. Tighten the bevel lock handle before
making a cut.
Fig. AA
COMPOUND CUT (FIG. BB)
A compound cut is the combination of
a miter and a bevel cut simultaneously.
1. Loosen the bevel lock handle (1)
and position the cutting head at the
desired bevel position. Lock the
bevel lock handle.
2. Loosen the miter handle (2). Lift up
the positive stop locking lever (3)
and position the table at the desired
angle. Release the positive stop
locking lever and lock the miter
handle.
Fig. BB
SLIDE CUTTING WIDE BOARDS UP
TO 12-1/4 in. WIDE (FIG. CC)
To avoid injury:
● Never pull the cutting head
assembly and spinning blade toward
you during the cut. The blade may
try to climb up on the top of the
workpiece, causing the cutting
assembly and spinning blade to kick
back, forcefully. The cutting head
assembly should be drawn back
completely then pushed forward
when sawing.
● Let the blade reach full speed before
cutting. This will help reduce the risk
of a thrown workpiece.
To Slide Cut Wide Boards (Fig. CC)
1. Unlock the carriage lock handle (1)
and allow the cutting head assembly
to move freely.
2. Set both the desired bevel angle
and/or the miter angle and lock into
position.
1
2
2
3
1
WARNING
!
1
2