Filter
Top Products
2 3
2 3
TABLE OF CONTENTS
SECTION PAGE SECTION PAGE
Warranty ............................................... 2 Know Your Compound Miter Saw .......... 10
Product Specifications .......................... 2 Glossary of Terms ................................. 11
Symbols .................................................. 3 Assembly and Adjustments ................... 12
Power Tool Safety ................................. 4 Operation ............................................... 19
Compound Miter Saw Safety ................. 6 Maintenance .......................................... 24
Electrical Requirements and Safety ...... 6 Troubleshooting Guide .......................... 25
Accessories and Attachments ............... 8 Parts List ................................................ 26
Tools Needed for Assembly .................. 8 Repair Protection Agreements................ 30
Carton Contents .................................... 9
WARRANTY
WARNING
!
Some dust created by using power tools contains chemicals known to the state of California to cause
cancer and birth defects or other reproductive harm. Some examples of these chemicals are:
●
Lead from lead-based paints
●
Crystalline silica from bricks, cement and other masonry products
●
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals, work in a well ventilated area and work with approved safety
equipment such as dust masks that are specially designed to filter out microscopic particles.
PRODUCT SPECIFICATIONS
MOTOR Cutting Capacity:
Power Source................
120V AC, 60Hz, 15 Amp Crosscut ........................... 2-5/8 in. x 5-1/2 in.
Arbor Shaft Size............ 5/8 in. Miter 45° R & L ................. 2-5/8 in. x 3-7/8 in.
Speed ........................... 4800 RPM (No load) Bevel 45° L ....................... 1-1/2 in. x 5-1/2 in.
Brake ............................ Electric 45° Miter and 45° Bevel .... 1-1/2 in. x 3-7/8 in.
Double Insulated .......... No Extension Wings ............... 2
MITER SAW BLADE
Rotating Table: Diameter ........................... 10 in.
Miter Detent Stops ....... 0°, 15°, 22.5°, 31.6°, 45° R & L Arbor ................................. 5/8 in.
Bevel Positive Stops .... 0°, 45° L
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120
Volt / 15 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord
immediately if it is worn, cut or damaged in any way.
Before using your tool, it is critical that you read and understand these safety rules. Failure to
follow these rules could result in serious injury to you or damage to the tool.
2009/03
CRAFTSMAN ONE YEAR FULL WARRANTY
If this Craftsman tool fails due to a defect in material or workmanship within one year from the
date of purchase, call 1-800-4-MY-HOME
to arrange for free repair (or replacement if repair
proves impossible).
This warranty applies for only 90 days from the date of purchase if this product is ever used for
commercial or rental purposes.
This warranty does not include expendable parts, such as lamps, batteries, bits or blades.
This warranty gives you specific legal rights, and you may also have other rights which vary
from
state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
R