Filter
Top Products
MOTOR AND BLOWER
TO BASE ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
1, Place motor and blower assembly and base on
their side with intake port pointing towards base,
Fig. 8
C
B B
A
5, Figure 9 shows the motor and blower assembly
attached to the side supports,
SUPPORT ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 10
B_
c
_B
2,
8,
4,
Align the four hobs, two shown (A) on the top of
both side supports (B) with four holes in the motor
and blower assembly (C), See figure 8,
Place a 5/16" lock washer onto a 5/16-18 x 3/4" hex
head screw and insert the screw through the side
support and thread screw into tapped hob in the
motor and blower assembly, Do not completely
tighten,
Repeat this process for the remaining three hobs;
tighten securely,
Fig. 9
A
1,
2,
8,
4,
5,
Place the support (A) inside the two side supports
(B), MAKE CERTAIN THE SUPPORT IS
ATTACHED TO THE SIDE SUPPORTS CLOSEST
TO THE MOTOR, See figure 10,
Align the four hobs (C) three shown, in the support
with the four hobs in the side supports, See figure 10,
insert a 5/16-18 x 5/8" hex head screw through the
side support and support,
Place a 5/16=18 flange hex nut onto the 5/16=18 x
5/8" hex head screw, Do not completely tighten,
Repeat Steps 3 and 4 for remaining three hobs
and tighten securely,
11