Filter
Top Products
UNPACKING AN{) CHECKING
CONTENTS (Figure 3)
This Dust Collector will require a minimal amount of
assembly,
Remove all of the parts from the shipping box and lay
them on a clean work surface, Compare the items to
figure 3, verify that all items are accounted for before
discarding the shipping box,
Fig. 3
if any parts are missing, do not attempt to plug in the
power cord and turn "ON" the Dust Collector, The Dust
Collector can only be turned "ON" after all the parts
have been obtained and installed correctly,
M
F
A
B
K
J
\
c
P
D
A, Motor and blower assembly
B, Base
C, Swivel caster (4)
D, Side support (2)
E, Filter bag
R Collection bag
G, Locking band (2)
H, Support
I, Filter Bag Hanger
J, Lower Support Rod
K, 4dnch flexible hose
L, 4dnch hose clamp (2)
M, 5/16-18 x 5/8" Hex head screw (12)
N, 5/16" Lock washer (4)
O, 5/16-18 Hex nut (1)
P, intake port cap
Q, 5/16-18 Flange hex nut (8) (not shown)
R, 3/8-16 Flange hex nut (4) (not shown)