Filter
Top Products
ADDITIONALRULESFORSAFEOPERATIONcont.
Z_ WARNING: Some dust particles created by power sanding, sawing,
grinding, drilling and other construction jobs contains chemicals known
to cause cancer, birth defects or other reproductive harm. Some examples
of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products.
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending upon how often you do this
type of work. To reduce your exposure to these chemicals:
• Work in a well-ventilated area.
• Work with approved safety equipment, such as those dust masks that are
specially designed to filter oul microscopic particles.
Z_ WARNING: The operation of any saw can result in
foreign objects being thrown into your eyes, which can result in
severe eye damage, Before beginning power tool operation,
ALWAYS wear safety goggles or safety glasses with side shield
and a full face shield when needed. We recommend A Wide
Vision Safety Mask for use over eyeglasses or standard safety
glasses with side shield, available at Sears Retail Stores.
The label on your tool may include the following symbols.
V.................................................................... Vo_ts
A...................................................................... Amperes
Hz................................................................... Hertz
W..................................................................... Watts
min................................................................. Minutes
"_..................................................................... Alternating current
-- ............................................................... Direct calTent
no ................................................................... No-load speed
[q .................................................................. Class IIconstruction
.../min .............................................................. Revolutions or Strokes per minute
.................................................................... Indicates danger, warning or caution.
It means attention! Your safety is involved.
IMPORTANT! READ ALL INSTRUCTIONS
Before attempting to use any tool, be sure tofamiliarize with all the operating
features and safety instructions.
Z_ WARNING: DO NOT let familiarity with your saw make you careless.
Remember that a careless fraction of a second issufficient tocause severe injury.
KNOWYOUR SAW (SEE Fig. 1)
Your Twin Cutter saw has many built-in convenience features for fast, efficienl cutting.
These features include a innovative 2-blade system with special blades that spin in
opposite directions to provide smooth, clean cuts. It also includes a prednstalled
blade lubricating system for use when cutting aluminum, copper, stainless steel and
cast iron. Tlle auxiliary handle mounts on the top of the saw to provide maximum
support and ease of handling.
For your convenience, there is no assembly required for your Twin Cutter Saw. The
]ecial 2-blade cutting system and the wax lubricating system are already installed.
Lock Nut
Wrench _ ..... ,
Assist Handle _.
Lower Blade
Guard Handle
Wax
Stick
Wax Lubricating
System Knob
Blades Lower Blade Guard
UNPACKING
Your Twin Cutter Saw has been shipped completely assernbled. Inspect the saw
carefully to make sure that no breakage or damage has occurred during shipping.
If any parts are damaged or missing return the saw to your nearest Sears Store to
have it replaced.
I
Z_ WARNING: If any parts are missing, DO NOT operate tbis saw until the I
missing parts are replaced. Failure to do So coud result in possible serious
I
personal injury
8 9