Filter
Top Products
RULESFORSAFEOPERATION(Continued)
Anextensioncord should notbe used unless
absolutelynecessary. Use of improper
extensioncord couldresult in a risk offire and
electric shock. If extensioncord must be used,
make sure:
a. That pinson plugof extensioncordare the
same number,size and shapeas those of
plugon charger.
b. That extension cord isproperlywired and in
goodelectrical condition;and
c. That wire size is large enoughforAC
ampere ratingof charger as specified
below:
Cord Length (Feet) 25 ft. 50 ft. 100 ft. 150 ft.
Cord Size (AWG) 16 16 16 14
Note: AWG = AmericanWire Gage
• DO NOT OPERATE CHARGER WITH A
DAMAGED CORD ORPLUG. If damaged,have
replacedimmediatelybya qualifiedserviceman.
M
Do notoperate chargerif it has received a
sharp blow,been dropped, or otherwise
damaged in any way; take itto a qualified
serviceman.
Do notdisassemble charger;take it toa
qualified serviceman when serviceor repair is
required. Incorrectreassemblymay resultin a
risk ofelectric shock or fire.
TOreduce riskof eleotncshock, unplugcharger
from outletbefore attemptingany maintenance
or cleaning.Turningoffcontrolswill notreduce
this risk.
M Do not use chargeroutdoors.
M Disconnect chargerfrom power supplywhen
notin use.
M SAVE THESE INSTRUCTIONS. Refer tothem
frequentlyand use them to instructotherswho
may use this tool. Ifyou loansomeone thistool,
loan themthese instructionsalso.
IMPORTANT INFORMATION FOR RECHARGING BATTERIES
When usingyour screwdrivercontinuously,the batteriesin your screwdriverwill become hot.Youshould letyour
screwdrivercool downfor approximately30 minutesbefore attemptingto recharge.
Note: This situationonly occurswhen continuoususe ofyourscrewddvercauses the batteries tobecome hot. It
doesnotoccur under normalcircumstances. Referto "CHARGING YOUR SCREWDRIVER" for normal
rechargingof batteries. Ifthe charger does notcharge yourscrewddverunder normalcircumstances,returnboth
the screwdriverand charger toyour nearest Sears repair center for electr_,alcheck.
_L WARNING:
The operation ofany powertoolcan resultin foreign ot_ysctsbeing throwninto your eyes,
which can result in severe eye damage. Before beginningpower tooloperation,always wear
safety gogglesor safety glasses with side shieldsand a full face shield when needed. We
recommendWide Vision Safety Mask for use over eyeglasses or standardsafety glasses
withside shields,available at Sears Retail Stores.
5