Filter
Top Products
,_ WARNING: To prevent accidental starting that
could cause possible sedous personal injury,
assemble all parts to your sew before connecting
it to power supply. Saw should never be
connected to power supply when you are
assembling parts, making adjustments, installing
or removing blades, or when not in use.
As mentioned previously your saw has been factory
assembled and adjusted. The dust guide and blade
are the only parts that have to be installed.
DUST GUIDE
See Figure 8.
To install the dust guide, place the end marked
INSERT over the exhaust port in the upper blade
guard. Turn the guide so that the open end isfacing
down or toward the rear of the saw.
• Unplug your saw.
WARNING: Failure to unplug your sew could
result in accidental starting causing possible
serious personal injury.
Push down on the sew arm and pull out the lock "
pin to release sew arm. Raise sew arm to itsfull
raised position. Be cautious, saw arm is spring
loaded to raise.
Loosen the phillips screw on the blade belt
cover until blade belt cover can be raised.
See Figures 9, 10, and 11.
Gently raise the lower blade guard bracket,
releasing lower blade guard from notch so that
lower blade guard and blade boltcover can be
rotated dp and back to expose the blade belt.
See Figures 9, 10, and 11.
EXHAUST
PORT
DUST GUIDE
TO INSTALL BLADE
See Figures 9, 10, and 11.
Fig. 8
_1= DANGER: A 8-1/4 in. blade is the maximum
blade capacity of your sew. Never use a blade
that is too thick to allow outer blade washer to
engage with the fiats on the spindle. Larger
blades will come in contact with the blade
guards, while thicker blades will prevent the
blade screw from securing the blade on the
spindle. Either of these situations will result in a
serious accident and can cause serious personal
injury.
PHILLIPSSCREW
LOWER BLADE
GUARD BRACKET
LOWER
BLADEGUARD
Fig. 9
PHIUJPS
SCREW
Fig. 10
13