Filter
Top Products
SQUARING THE BLADE TO THE
MITER TABLE
See Figures 21 - 24.
• Unplug your saw.
A WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
• Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
• Lift up the miter table clamp.
• Rotate the miter table until the pointer is posi-
tioned at 0°.
• Push the miter table calmp back down.
• Loosen bevel lock knob and set saw arm at 0°
bevel (blade sat 90° to miter table). Tighten bevel
lock knob.
• Place a combination square against the miter
table and the flat part of saw blade.
Note: Make sure that the square contacts the fiat
part of the saw blade, not the blade teeth.
• Rotate the blade by hand and check the blade-to-
table alignment at several points.
• The edge of the square and the saw blade should
be parallel as shown in figure 21.
FENCE
BLADE
COMBINATION MITERTABLE
SQUARE
CORRECTVIEWOF BLADE
SQUAREWIIH MITERTABLE
Fig. 21
If the top or bottom of the saw blade angles away
from the square as shown in figures 22 and 23,
adjustments are needed.
FENCE
BLADE
COMBINATION MITERTABLE
SQUARE
VIEWOFBLADENOTSQUAREWITHMITER
TAIBL_ADJUSTMENTSAREREQUIRED
Fig. 22
FENCE
BLADE
COMBINATION MITERTABLE
SQUARE
VIEWOFBLADENOTSQUAREWiTHMITER
TABLE,ADJUSTMENTSAREREQUIRED Fig. 23
18