Filter
Top Products
SQUARING THE MITER TABLE
TO THE FENCE
See Figures 13 - 16.
• Unplug your saw.
_lk WARNING: Fallur_ to unplug your saw could
result in accidental starting causing possible
serious personal injury.
Push down on the saw arm and pull out the lock
pin to release the saw arm.
Raise sew arm to its full raised position,
Lift the miter table clamp.
Rotate the miter table until the pointer is posi-
tioned at 0°.
Push the miter table clamp back down.
Lay a framing square fiat on the miter table. Place
one leg of the square against the fence. Place the
other leg of the square beside the zero clearance
throat plate in the miter table. The edge of the
square and the zero clearance throat plate in
the miter table should be parallel as shown in
figure 13.
FENCE
FENCE
FRAMING ZEROCLEARANCE
SQUARE THROATPLATE
MITERTABLE
ViEWOFMITERTABLENOTSQUAREWITH
FENCE,ADJUSTMENTSAREREQUIRED Fig. 14
FRAMING ZEROCLEARANCE
SQUARE THROATPLATE
FENCE
MITERTABLE
FRAMING
SQUARE
MITER
TABLECLAMP
ZEROCLEARANCE
THROATPLATE
ViEWOFMITERTABLESQUAREWITH
FENCEANDCORRECTLYADJUSTED
Fig. 13
If the edge of the framing square and the zero
clearance throat plate in the miter table are not
parallel as shown in figures 14 and 15, adjust-
ments are needed.
MITER TABLE
ViEW OFMITERTABLENOTSQUAREWITH
FENCE,ADJUSTMENTSAREREQUIRED Fig. 15
Using a 6 mm hex key, loosen the socket head
screws securing the fence. See Figure 16. Adjust
the fence left or right untilthe framing square and
zero clearance throat plate are parallel.
6mmSOCKET _
_ v Fig. 16
• Retighten the screws securely and recheck the
fence-to-table alignment.
16