Filter
Top Products
SQUARING THE SAW BLADE TO THE
FENCE
See Figures 17- 20.
• Unplug your saw.
_1, WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
• Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
• Lift the miter table clamp.
• "Rotate the miter table until the pointer is posi-
•tioned at 0°.
• "Push the miter table clamp back down.
• Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Slide the
other leg of the square against the fiat part of saw
blade.
Note: Make sure that the square contacts the fiat
part of the saw blade, not the blade teeth.
• The edge of the square and the saw blade should
be parallel as shown in figure 17.
• If the front or back edge of the saw blade angles
away frem the square as shown in figures 18 and
19, adjustments are needed.
• Using the 6 mm hex key provided, loosen the
socket head screws that secure the mounting
bracket to the miter table. See Figure 20.
• Rotate the mounting bracket left or right untilthe
saw blade is parallel with the square,
• Retighten the screws securely and recheck the
blade-to-fence alignment.
FENCE
BLADE
FENCE
FENCE
6 mmSOCKIET,.
HEADSCREW(S)
BLADE
MITERTABLE : FRAING SQUARE
VIEWOF BLADENOTSQUAREWITH
FENCE,ADJUSTMENTSAREPJEQUIREDFig. 18
BLADE
II"ER TABLE FRAMINGSQUARE
VIEWOF BLADENOTSQUAREWITH
FENCE,ADJUSIMENI'SAREREQUIRED Fig. 19
MITERTABLE FRAMINGSQUARE
VIEWOF BLADE
SQUAREWTI'HFENCE Fig. 17
O
6 nunHEXKEY
17
MOUNTING
BRACKET
\
MITERTABLE
Fig. 20