Filter
Top Products
30
31
WRONG
Fig. 40
WARNING: To avoid a kickback and to avoid
serious personal injury, never position the concave
edge of bowed or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 41.
When cutting wide workpieces such as a 2 in. x 6 in.,
boards should be clamped with a C-clamp as shown in
figure 41.
Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save right end of cut
33.85
°
33.85
°
33.85
°
33.85
°
Fig. 41
CUTTING WARPED MATERIAL
See Figures 39 - 40.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side
against the fence as shown in figure 39.
If the warped material is positioned the wrong way as
shown in figure 40, it will pinch the blade near the comple-
tion of the cut.
Fig. 39
RIGHT
WIDE
BOARD
OPERATION