Filter
Top Products
SPECIFIC SAFETY RULES FOR CORDLESS RIGHT ANGLE IMPACT DRIVER _]__o_j
Hold power tools by insulated gripping surfaces when performing an
operation where the tool may contact hidden wiring or its own cord.
Contact with a "live" wire will also make exposed metal parts of the tool
"live" and shock the operator.
Secure the workpiece. Clamping devices or a vise will hold the workpiece
in place better than the hand
Always wait until the machine has come to a complete stop before
placing it down. The tool can jam and lead to loss of control over the power
tool.
Before performing any kind of work on the machine (e. g., maintenance,
tool change, etc) as well as when transporting and storing it, always
set the rotational direction switch to the center position. Unintentional
activation of the On/Off switch may result in personal injury.
Do not open the battery. There is risk of a short circuit.
Protect the battery from heat and fire. There is risk of explosion.
Wear ear protectors with impact drills. Exposure to noise can cause
hearing loss
Use protective gloves when removing the bit from the tool, or first allow
the clamp to cool down. The bit may be hot after prolonged use.
Use protective gloves when operating the tool. Protective gloves can help
to keep you from being burnt and hurt.
Keep your hands away from the motor-housing vents. Hot gas comes
from the vents during operation.
Do not operate the tool at full-load for more than 30 seconds, as this can
cause the motor to become too hot, which may damage the motor.
Release the trigger immediately when the fasteners are sufficiently
tightened to avoid breaking the fasteners.
For best results, your battery tool should be charged in a location where the
temperature is more than 32°F (O°C) but less that 104°F (40°C). Do not store
outside or in vehicles.
KNOW YOUR RIGHT-ANGLE IMPACT DRIVER (Fig.l)
Fig. 1
Sleeve
LED
Worklight
Variable
Speed Trigger
Switch
Direction of
Rotation Selector
(Forward/Center
Lock/Reverse)
Battery Release
Button
Battery Pack
FuelGauge
PRODUCT SPECIFICATION
Motor 12 Volt DC
Collar 1/4"
Switch VSR (Variable Speed Reversible)
No Load Speed 0-2100 RPM
Impacts per minute 0-3400 BPM
Torque 700 in.lbs
Driver Weight (without battery) 1.83 Ibs (without battery)
Battery Type Lithium-Ion
Battery Voltage 12 Volt DC
Charger Input 120-Volts, 60 Hz AC only
Optimum Charging Temperature 32°F (0°C) -104°F (40°C)
17562 ManuaLRevised_lO 0607 Page 917562 Manual_Revised_SO 0607 Page 8