Filter
Top Products
14
Attaching Table Supports
1. Attach a table support to each side of the
saw using the four hex head bolts and flat
washers. Put the bolts through the center of
the enlarged holes in the table supports so
that the supports may slide up or down as
needed. Put a lockwasher and hex nut on
each bolt and hand tighten.
NOTE:
The goal in adjusting the table supports
and leveling the front table is to make sure that
the table is the same distance from the radial
arm at all points. This ensures that when the
table and blade are installed the clearance
between them will be equal at all points.
Positioning Table Supports
1. Release bevel lock lever, move bevel
index lever to the left and rotate the motor to
position arbor shaft down. Lock bevel lock.
2. Unlock and hold miter/arm lock lever in
index release position as shown. Position
arm against left stop (approximately 50°
miter). Loosen carriage lock knob (rip lock)
and position arbor shaft directly over left
hand table support.
3. Slide the arbor wrench handle between
end of motor shaft and table support to act
as a feeler gauge. Carefully lower the motor
with elevation crank until the end of shaft is
just touching the arbor wrench. The wrench
should slide back and forth with only slight
resistance. Tighten screw “A”.
NOTE:
Do not change this elevation setting
until both left and right hand table support
channels have ben adjusted.
4. Move arm and carriage to screw “B”.
Adjust position of table support so that the
arbor wrench just slips between the end of
the motor shaft and the support. Tighten
screw “B”.
5. Move arm and carriage to right hand table sup-
port and level in the same manner as in step 4.
6. Recheck both support channels to make
sure that tightening screws did not affect the
accuracy of the adjustment.
7. Elevate the saw and return motor to hori-
zontal position to provide clearance for
installation of front work table.
Lockwasher
Nut
Table Support
Front
Flat Washer
Hex Head
Table Support
Screws
Here
Mount Support
Using These Holes
Bolt
Arbor
Screw “A”
Arbor Wrench
Screw “A”
Screw “B”
Table Support
Wrench
Assembly
Installing Table Boards (40" Wide Models) For 44" Wide Models Skip to Page 17