Filter
Top Products
23
13. Using the two #8 x 3/4 pan head screws
provided, attach the new handle in the same
way as the old one was removed.
14. Inspect motor support cone on yoke, and
cone on motor for lubrication on contacting
surfaces. These surfaces should be gener-
ously lubricated. If necessary lubricate with
lithium white grease (not supplied).
15. Reinstall motor on motor support. Line
up the index pin with the slot in the index
plate. Reinstall the .505 x 7/8 x 1/16 washer
and 1/2-13 locknut. Take care not to drop
washer in opening of motor. Tighten nut until
the bevel lock lever will lock the motor in any
position when in the lock position. With the
bevel lock lever in the unlocked position
move the motor to any of the five index posi-
tions.
If motor does not index securely, the adjust-
ment is too loose.
Caution: On electronic models be
sure bevel control unit is engaged with
motor index plate before installing
washer and lock nut.
16. Reinstall the motor support cap.
Lubricate Cone & Motor
At Point of Contact
Motor Index
Plate
Bevel Control
Unit
Assembly