Filter
Top Products
CHEST TOP INSTALLATION AND REMOVAL
(With task light)
Tools Required:
3/8" Wrench
Chest Top Removal
• Disconnect power from unit.
• Remove enough drawers to reach the
top back inside of the unit. (See
Drawer installation and removal.)
• Push actuator rod to back of unit to
disconnect from back of lock. Move
actuator rod for access.
• Remove (4) screws holding top in
place.
• Lift top off of unit enough to reach the
wiring harness.
• Disconnect wiring harness from unit.
• Remove top from unit.
Chest Top Installation
• Connect wiring harness to top.
• Position top on unit.
• Attach using (4) screws.
• Make sure the back of the actuator
rod is inserted into the actuator rod
holder in the back of the unit.
• Push actuator rod toward back of unit
and line up with lock. Insert the
actuator rod into the back of the lock.
• Test lock operation.
• Reinstall drawers.
• Reconnect power to the unit.
Top
Press to
release
Disconnect
actuator rod
Actuator rod
holder
Remove
screws
DRAWER AND WORK SURFACE
INSTALLATION AND REMOVAL
Note: For pull out work surface without
task light, follow drawer removal
instructions.
DRAWER
• Empty the drawer.
• Fully extend the drawer.
Release
Lever Style - Lift or
lower (depending on the
slide) the release lever
on both sides, (this
allows the slides to ride
over the stops.) Pull out
to remove.
Tab Style - Depress the
release tabs on both
sides, (this allows the
slides to ride over the
stops.) Pull out to
remove.
• To reinstall, carefully align the slides
and push the drawer into the unit until
the drawer stops.
PULL OUT WORK SURFACE WITH
TASK LIGHT
Removal
• Disconnect the power from the unit.
• Remove enough drawers to gain
access to connections in the back of
the roll-away behind the work surface.
• Unplug work surface cord from back of
roll-away.
• Remove and save back retaining clip.
• Disconnect chain inside back of roll-
away. (Move chain toward large round
part of slot. Pull out to remove.)
• Remove the work surface. (See
drawer removal instructions.)
Retaining
Chain
Installation
• To reinstall, carefully align the slides
and push the work surface into the unit
until the work surface stops.
• Depress release tabs in back corners
of the extendable work surface.
• Push the work surface into the unit to
the fully retracted position.
• Extend work surface far enough to
gain access to connections in back.
• Connect chain inside back of roll
away. (Insert chain into the large
round part of the slot. Slide chain to
small end of slot.)
• Insert retaining clip to hold chain in
place.
• Plug work surface cord into back of
roll-away.
• Reconnect power to the unit. (See:
Connecting power.)
• Check work surface and task lighting
for proper operation.
• Reinstall drawers.
5 6