Filter
Top Products
13. DISCONNECTTOOL when not in
use, before servicing and when
loading or changing accessories.
14.AVOID UNINTENTIONAL
STARTING. Never carry tool with
your finger on the switch.
15.STAY ALERT, Watch what you are
doing and use common sense. Do
not operate tool when you are tired
or under the influence of drugs,
alcohol, or medication.
16. CHECK DA;w;AGED PARTS. Before
using tool, check that all parts will
operate correctly and will perform as
designed. Any damaged parts
should be repaired or replaced by
an authorized Sears service facility.
Also, check for misalignment,
binding, and broken parts. Check
that the switch works properly and
DO NOT USETOOL IFTHE
SWITCH DOES NOTTURN THE
TOOL ON AND OFF.
17. REPLACEMENT PARTS, When
servicing, use only identical
replacement parts ordered from a
Sears service facility.
18.WEAR HEARING PROTECTION
during extended periods of
operation.
GUIDELINES FOR
EXTENSION CORDS
If you are using an extension cord
outdoors, be sure it is marked with the
suffix "vV-A" ("_/" in Canada) to indicate
that it is acceptable for outdoor use.
Be sure your extension cord is
properly wired, and in good electrical
condition. Always replace a damaged
extension cord or have it repaired by a
qualified person before using it.
Protect your extension cords from
sharp objects, excessive heat and
damp or wet areas.
(when using 120 volts only)
Ampere Rating
more than not more than
0 6
6 10
10 12
Totallengthofcordln feet
25' 50' 100' 150'
18 16 16 14
18 16 14 12
16 16 14 12
WEAR YOUR
ALWAYS WEAR EYE PROTECTION. Any Power Tool
can throw foreign objects into4he eyes which could
cause permanent eye damage. ALWAYS wear safety
Goggles (not glasses) that comply with ANSI safety
standard Z87.!. Everyday glasses have only
impact-resistant lenses...they ARE NOT safety glasses.
Safety Goggles are available at Sears.
NOTE: Glasses or goggles not in compliance with
ANSI Z87.1 could seriously hurt you when they break.
SAVE THESE INSTRUCTIONS
Page 4