Filter
Top Products
Housing cap --
Housing
Safety lock pin
Trigger switch
t
g mouth
cord
Latch
Nail magazine
HOW TO LOAD YOUR BRAD
NAILER (FIGURE 1)
1. Unplug nailer from power source.
2. Use only brad nails recommended;
see brad nail chart.
3. Push up the latch (1) toward the
magazine and slide out the
magazine (2).
4. Position the nailer exposing the
magazine chamber (3).
5. Load nails into the magazine, nail
points facing down toward the bottom
of the nailer.
6. When loading different lengths,
do not load nail heads into the
upper part of the slot.
Load se that the nail points are at
the bottom of the magazine (4).
7. Close magazine (2), making sure that
the nails stay seated in the track.
8. Make sure that the latch (1) is
securely locked.
Fig. 1
/_ To avoid personal injury, keep fingers
Proper loading off the trigger until ready to drive nail.
Do not point the nailer at anyone when
the nails are loaded.
4 3
Page 7