Filter
Top Products
TO NAIL (FIGURE 2)
Always wear safety goggles or safety
glasses with side shields when
operating your nailer. Failure to do so
could result in objects being thrown
into your eyes, resulting in possible
serious injury.
1. Plug nailer into 120 Volt, 60Hz
power outlet,
2. Hold nailer firmly with the tacking
mouth (1) flat to the workpiece.
Do not allow familiarity of your nailer to
make you careless. Remember that a
careless fraction of a second is sufficient
to inflict severe injury.
Fig. 2
4
3
Use enough downward pressure to _/3. depress the safety lock pin (2).
NOTE: The safety lock pin must be _,,,_ _'f-_
depressed for this nailer to operate. _ _ \ _ !
This nailer will not fire uniess this f/_ / /'_--._ "'-)1
is done. _._;_ /// k_
J
4. Squeeze the trigger (3) to drive the _ k.'_......__ 1
brad nail. L ___ I
5. If the workpiece is very hard, press _ _'_" /J
down on the housing cap (4) with _ _'_ I/
your free hand. _._
NOTE: AVOID BLANK SHOTS to
prevent wear and damage to 2
internal parts. 1 J
The nailer must be disconnected from
the electrical power source during
maintenance.
STANDARD MAINTENANCE
1. Inspect all screws and tighten
if necessary.
2. Use a clean cloth to remove dirt
from the tool.
3. Do not use gasoline, brake fluid, oils,
or solvents to clean plastic parts.
These chemicals will damage,
weaken, or destroy plastics.
4. Do not oil or grease any parts,
5. Keep the nail magazine chamber
clean.
6. Do not rotate or remove housing
cap.
Do not alter, redesign parts on this
nailer, or attach special fixturing. This
can be a source of personal injury.
Page 8