Filter
Top Products
25- ENG
A09713
PROBLEM
CAUSE
CORRECTION
Compressor is
not supplying
enough air
to operate
accessories.
Prolonged excessive use
of air.
Compressor is not large
enough for air requirement.
Hole in hose.
Check valve restricted.
Air leaks.
Restricted air intake filter
Decrease amount of air usage.
Check the accessory air
requirement. If it is higher than
the SCFM or pressure supplied
by your air compressor, you
need a larger compressor.
Check and replace if required.
Remove and clean, or replace.
Tighten fittings.
Clean or replace air intake
filter. Do not operate the
air compressor with the
filter removed. Refer to the
"Air Filter" paragraph in the
"Maintenance" section.
Pressure reading
on the outlet
pressure gauge
(if equipped)
drops when an
accessory is
used.
It is normal for "some"
pressure drop to occur.
If there is an excessive amount
of pressure drop when the
accessory is used, adjust the
regulator as instructed in the
Operation section.
NOTE: Adjust the regulated
pressure under flow conditions
(while accesory is being used).
Possible defect in safety
valve.
Operate safety valve manually
by pulling on ring. If valve still
leaks, it should be replaced.
Air leak from
safety valve.
Clean or replace. See "Air
Filter" paragraph in the
"Maintenance" section.
Dirty air filter.
Restricted air
intake.
Loose belt.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Damaged regulator. Replace.Regulator knob
has continuous
air leak.
Regulator will
not shut off air
outlet.
Damaged regulator. Replace.