Filter
Top Products
27- ENG
A09713
PROBLEM
CAUSE
CORRECTION
Knocking Noise.
Possible defect in safety
valve.
Operate safety valve manually
by pulling on ring. If valve still
leaks, it should be replaced.
Loose pulley Tighten pulley set screw;
see Parts manual for torque
specifications.
Compressor mounting
screws loose.
Tighten mounting screws;
see Parts manual for torque
specifications.
Loose flywheel Tighten flywheel screw; see
Parts manual for torque
specifications.
Loose belt.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Carbon build-up in pump. Have checked by a Trained
Service Technician.
Belt to tight. Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Excessive belt
wear.
Loose belt.
Tight belt.
Loose pulley.
Have checked by a Trained
Service Technician.
Pulley misalignment.
See "Motor Pulley/Flywheel
Alignment" paragraph in the
"Maintenance" section.
Squealing
sound.
Loose belt.
Compressor pump has no
oil.
See "Oil-Checking" paragraph
in the "Maintenace" section.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Defective check valve. Remove and clean, or replace.